Volvo RWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2002

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

NO grease on suspension bushings.

posted by  Zee on  Fri Aug 29 01:11 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Oct 27 10:07 CST 2012
[RELATED]

After reading the FAQ (after the fact) about replacing front radius arm busihings, I see the caution not to use grease on rubber bushings because that will tend to degrade them.

That's contrary to some advice I have seen where the application of nickel-based anti-sieze was suggested as a remedy for squeaking sway bar-to-frame bushings.

So, I followed that advice and lubed the POLY radius arm bushings with anti-sieze. I also lubed the insides of the *rubber* sway bar-to-frame bushings with anti-sieze.

Did I do wrong?
--
"Can't understand why people abort Volvos, either"






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New NO grease on suspension bushings.
posted by  Zee subscriber  on Fri Aug 29 01:11 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.