Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

My new wheel bearing race is too darned small. What's up? 200 1989

posted by  someone claiming to be 2OldVolvos on  Wed Sep 3 14:11 CST 2003 [RELATED]


I just had the front left inside wheel bearing go on my wife's 1989 240 DL sedan.

I drove the old bearing race out, cleaned everything up, and went off to the parts store.

To make a long story short, the bearings the parts store sold me are a hare too small for my wheel. The race fits in the hole but it is loose enough to turn my hand. The one I took out was a tight pressed fit as I would expect.

I tried 3 bearings and 2 manufacturers (Timken and SKF). All see to be too small.

The one I took out was SKF brand made in Germany, part number K-L68111/CL3. The parts I purchased all had the 68111 number on them so I dont think the parts people are in error.

Anyone ever have this problem? Is it OK to use it with the race fitting so loosley? Is is safe to use locktite or some other way to tighten it up? Please advise. Thank you.

It's always something.

2OldVolvos





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New My new wheel bearing race is too darned small. What's up? [200][1989]
posted by  someone claiming to be 2OldVolvos  on Wed Sep 3 14:11 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.