Volvo RWD 140-160 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2002 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Alignment attempt 140-160 1974

posted by  uniberp on  Wed Oct 15 06:44 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Jan 31 07:08 CST 2011
[RELATED]

My 74 145 pulls slightly to the left. All tires rotated around, all brakes/bearings checked, toe-in played with and set to 0".

I'm thinking that slightly more caster on the front left might straighten it out, that is, one more thin shim under the upper a-arm rear shaft bolt. Is this a good place to start?

I've also heard that adjustment with this means is a bad idea altogether, that it stresses the shaft or bolts excessively, and that fron suspension adjustments should be made between the crossmember and the body. How would that change just one side, by bending the crossmember?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Alignment attempt [140-160][1974]
posted by  uniberp  on Wed Oct 15 06:44 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.