Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Rear engine crankshaft seal question...... 200

posted by  Goldy on  Tue Oct 21 11:57 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I installed a new rear engine crankshaft seal in my 78 242 B21 engine.

I used the old seal as a contact to tap the new one in. Inadvertently, I pressed the new one in further thatn the old one was - about 1/8" further.

It is in nice and even all around - but is it ok where it is seated?

Do I need to remove it?

Can it be removed without damaging it (this I doubt)

Thanks in advance...





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Rear engine crankshaft seal question...... [200]
posted by  Goldy  on Tue Oct 21 11:57 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.