Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

How Much Compression Is Too Much? 200

posted by  someone claiming to be Phil on  Tue Oct 21 13:53 CST 2003 [RELATED]

Over the past year, my brick's compression in each cylinder (1/2/3/4) has slowly increased on 7/27/2002 of 145/145/146/153 psi, on 6/30/03 of 150/157/156/160 psi, and 166/171/172/174 psi today. The differences between cylinders is proportional, so I doubt that my technique is off. Besides, I'm using the same compressor tool with its braided tubing. This increase in compression is counterintuitive, unless I am taking better care of the engine. My flame trap is clean, but I'm a little concerned that an increase in the compression could be a bad thing. Your thoughts?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New How Much Compression Is Too Much? [200]
posted by  someone claiming to be Phil  on Tue Oct 21 13:53 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.