Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2010

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

CAMBER Out Of Spec & RIDE HEIGHTs FUBAR

posted by  dakinecar on  Wed Oct 29 14:57 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

944 TURBO w/158Kmis.

Front end camber is out of spec. Tires have worn very unevenly, causing a lot of noise and vibration. Today I replaced all four tires.

Data:

Camber is: 0.9o (left) and -0.9o (right), out of the -0.2o to +0.8o spec.

The ride heights to the lifting point bars are as follows:
Frt Rear
left side 4 1/2” 4 1/2”
rt side 4 15/16” 5 1/8”

Obviously the right side of the car is outside the ¼” margin Ringlee quotes. And the higher height on that side would directly cause negative camber.

Question is: what’s causing this? What is the fix?





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New CAMBER Out Of Spec & RIDE HEIGHTs FUBAR
posted by  dakinecar  on Wed Oct 29 14:57 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.