Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

What would you do??? 200

posted by  VolvoSolver on  Sat Nov 1 15:31 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

This was from a post in the archives regarding 02 sensor tests.

"The other easy way used is to check voltage at the O2 sensor single wire lead while plugged in (move rubber boot away), engine at operating temp and running using a volt guage. It should fluctuate between 0-1.0 volts quickly at idle if it's working, not stuck at 0.6 volts for example."

On my car (89 240 dl wagon) I did this test and the car reads a rock steady .58 volts. Does this mean the sensor is dead?? Why no "fault in 02 sensor signal" code at the OBD box. Thanks for any help, Steven






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New What would you do??? [200]
posted by  VolvoSolver  on Sat Nov 1 15:31 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.