Hello fellow tractor lovers.


I have a B16 engine car and would like to put a new clutch in it. It came with a 8 inch borg andd beck clutch with the early type three prong preasure plate and and throwout bearing. Finding a rebuilder for the clutch is expensive and might not be the best solution.

I put a later 8 1/2 inch clutch on it and the clutch preasure plate bolt in the same six holes on the preasure plate. I will try to use a later Borg and beck type preasure plate to fit the 8 1/2 disk.

The only thing I need to do is to cut down the stepped surface of the flywheel so the surface will be flat and can take the wider 8 1/2 disk. Has any one done this conversion? Also I need a Borg and beck throughout bearing for volvo's 1967 later. They are different than the ones used on the earlier borg and beck and also different than the F and S clutches. I need your advice please and any sources for the later Borg and beck thourghout bearing would be very helpful.

Thanks so much from John "Erik" Sandlund Lynden Washington near Bellingham

1959 volvo Pv445
1982 volvo 345GLS in the states
1984 volvo 360GLS in Panama