91, 740
155,000

Here is the most complete list I could develop. There may be other special tools as well. Btw, I posted this unfder the 200 forum as well. Didn't get any hits on the ALL/ALL forum.


740 Steering wheel tool, #998 8695
740 Strut holder hook tool #5045
740 Strut tool bushing drift #2704
740 Control Arm Ball Joint Press # 5259
740 Control Arm Bushing Press out # 5091, 5240
740 Control Arm Bushing Press in # 2904
740 Track Rod tools in/out bushings# 2731, 2733; 2706


Automatic trans drive flange holder and seal driver # 5075 and # 5149.

Brake tool # 2919 piston chamfer tilter, to stop squealing
Brake tool # 2918 for 20 degree tilt

Cam & Intermediate shaft sprocket holder, #5034
Cam and Intermediate shaft, Seal driver # 5025

Clutch Alignment tool, # 5111

Control Arm (740) - # 5356, 5359, 5078
Control Arm tool, to remove & install Front control arm bushing, # 5084, # 5085, # 5091
Control Arm tool, to remove & install Rear control arm bushing, # 5082, # 5083, # 1801

Crank Pulley holder # 5284
Crank Seal Intstaller # 5283

Engine Stand and fixture, # 2520 & 5297
Engine Rear Oil Seal tools #5276, # 1801
Engine Removal Install Lifting Sling & Yoke, # 2810 & # 5035
Engine Holding tools, for oil pan/motor mounts, # 5006, 5115, 5035 (2x5003?), 5871

FI pressure tester # 5011, #5228, #5229

Flywheel locking tool # 5112


Ignition switch/steering # 5294, #5295 to press out lock

Man.Trans, 5th gear tools: #"s 5986; 5973; 998-7693; 5262; 5305; 2985; 5058; 5148; 5147
Manual trans oil filter and check valve remover and installer, etc. #2836

Pressure Gauge, # 2834

Rear axle puller and bearing puller # 2709
Rear axle puller for flange # 2261
Rear axle seal puller # 5069

Shock Absorber holder and Strut loosening tool # 5036, # 5037

Steering arm, to press rod out of # 5043

Strut camber adj tool # 5038
Strut tools for front cartridge # 5039, # 5046, # 5303

Suspension, Rear torque arm bushing tool # 5086, # 5087
Suspension, Rear track rod bushing tools # 2731, # 2733, # 2706
Suspension, Rear Trailing Arm bushing, #5078, #5079
Suspension, Front Trailing Arm bushing, # 5087, #5088

Transmission, manual trans pilot bearing remover # 4090
Transmission, manual trans pilot bearing installer # 1426
Transmission support for install and removal # 5972

Trunk lid tool - to remove & install sedan lid gas shock, # 2744, # 5211

Valve guide press out tool # 5218
Valve guide reaming tool # 5224
Valve clearance measuring tool # 5222
Valve compressor, Intake & exhaust # 5022
Valve disc remover # 5026

Wheel tool - to press out wheel studs # 2862
Wheel tool - to remove front wheel hub # 2722


thanks -- diyer