Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

240 driver's seat rebuild 200 1983

uid 55's pic
posted by  john sargent on  Sun Nov 23 16:04 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 22 09:07 CST 2014
[RELATED]

Last night I re-built the driver's seat in the recently purchased 1983 244. I used 0.032" aviation stainless steel safety wire to replace the long since degraded jute and poly fiber string which connects the cross wires for the seat bottom support. In the first picture it is a little hard to the safety wire, but the second picture shows it well on the center of the seat bottom support. I also put a slight bned on the front of the side wire to keep the front springs from sliding off of them.


--
john






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 240 driver's seat rebuild [200][1983]
posted by  john sargent subscriber  on Sun Nov 23 16:04 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.