Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2005 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Suitable solder/soldering equipment? & how do I include a photo in message? 700 1987

posted by  Kjartan Langskog on  Thu Nov 27 21:57 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Jul 20 07:49 CST 2011
[RELATED]

I have (hopefully) successfully resoldered the fuel pump relay which appears due to solder cracking to have been the reason for my no start incident, but realised that my technique, solder and soldering iron (25W) were not up to scratch resulting in difficulty to make the solder flow and a clumsy repair. Is there a special solder and soldering iron to use for this kind of job, and is there a special technique involved in heating the new solder and terminals/existing solder to achieve a good flow and smooth appearance. Once the new solder was placed on the relay board I found it very difficult to make it heat and flow.

After the work I wanted to post a message with a picture taken with my digital camera of the completed relay. How do I do that, and do I have to reduce the size of the file?

Any help greatly appreciated.
--
Kjartan Langskog






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Suitable solder/soldering equipment? & how do I include a photo in message? [700][1987]
posted by  Kjartan Langskog  on Thu Nov 27 21:57 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.