Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2002 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

A simple solution to a PITA problem!!! 900

posted by  someone claiming to be xallenx on  Sat Jan 10 07:23 CST 2004 [RELATED]

WEll,





I finally figured out what caused my 940 SE to stall out and then after a while it was difficult to re-start but when left a few minutes it started out fine but the idle was rough and the car would stall. I checked every thing from relays to RPM senosrs, fuel pump, MAF, etc. But guess what the rpoblem was...the stupid black plastic connector on my windhsield wahser line.the one that has the red top and connects the main line to the left and right nozzles!! The stupid thing leaks water and everytime i use it it sprays water on to the distributor cap and this is what caused my car to stall and have fluctuating RPM. So..lesson learned..anyone having this type of problem check to see if this is the case for your car. What is this red top plastic connector for anyways? Could I just purchase a plastic T connector to replace this leaking part? thanks..

xallenx
91 940 SE
156K+miles, AW71, Mitsu TD04






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New A simple solution to a PITA problem!!! [900]
posted by  someone claiming to be xallenx  on Sat Jan 10 07:23 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.