Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2010 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

'89 b230ft turbo exhaust manifold issue 700

posted by  steve m on  Thu Feb 5 15:06 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun May 4 02:48 CST 2008
[RELATED]

Quite the week ..new distributor installed (ouch, just the distributor!) flat tire, fixed the turn signal's after they quit, all this on my daily driver.

Next is fixing a cylinder #3 exhaust manifold leak. I went to tighten the manifold bolts ,,,,,, one was already broken and gone; first I tried tightening broke when I put force on it so obviously I need all new studs and nuts.
Can I disconnect and remove the mitsubishi turbo and still drive the car if I need to do this in stages?
Sounds like I have a 50% chance getting the other studs out rather easily reading the FAQ's but I need the car daily.

As alway's, thanks for the help
--
steve m






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New '89 b230ft turbo exhaust manifold issue [700]
posted by  steve m  on Thu Feb 5 15:06 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.