Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2010 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Help needed on removing broken brake bleeder screw 200 1989

posted by  guYom on  Wed Feb 11 01:02 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Jul 5 17:35 CST 2013
[RELATED]

See my previous post...

I need some suggestions and advise please.

I broke one the two left front bottom brake bleeder nipple (screw) while doing a flush/bleed job. I was using a pressure bleeding system (Eezi bleed). That went fine, no air in the system and fresh fluid in now.

I assume I could just drive like that and not worry about it. But I would prefer removing the broken screw and replacing it with a new one if I can do that with an inexpensive tool (I don't have a drill, so can't drill it out).

I need your help and input on this !

Thanks in advance fellow bricksters.
--
'89 244DL M47 159K miles






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Help needed on removing broken brake bleeder screw [200][1989]
posted by  guYom  on Wed Feb 11 01:02 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.