Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 12/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

exhaust hits after changing engine and tranny mounts 200 1990

posted by  lrisius on  Sat Feb 14 08:10 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Aug 17 05:59 CST 2014
[RELATED]

Hi,
I just replaced both motor mounts and the tranny mounts on my 90 240 with new ones from FCP Groton. The exhaust pipe is now hitting the tranny crossbar. It primarily does it when starting and when in reverse. I don't think it does it when in drive. My guess is that I raised the engine up enough to make it start hitting. The new mounts also seem "springier" than my old hardened ones. I've tried to adjust the intermediate muffler to get maximum clearance. Any other thoughts or ideas?
Thanks!
Lyle






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New exhaust hits after changing engine and tranny mounts [200][1990]
posted by  lrisius  on Sat Feb 14 08:10 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.