Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 10/2009 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Map Pocket Reinforcement 200

posted by  dbrick on  Wed Feb 18 14:16 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 17 12:00 CST 2014
[RELATED]

Several posters (B.C. and Don Foster) have written about reinforcing 240 map pocket edges with strips of metal, bolted and epoxied behind the pocket's top edge. Sounds reasonable to me.

Now I've gotten a set for Cam's car, so I'm faced with actually doing the job. Did you put the reinforcement only on the edge of the "deep" part of the pocket, or does it also go along the edge through the "shallow" part too? And if it's on the shallow part too, what do you do at the vertical web in the middle? Two separate metal pieces? Cut a slot in the web? What did you do with the curve from the deep part of the pocket back to the pocket part by the door panel?

Whew. Thanks!
--
David Brick, Santa Cruz CA






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Map Pocket Reinforcement [200]
posted by  dbrick  on Wed Feb 18 14:16 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.