Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Brake Junction Box (Brake Failure) Replacement, Easy or Hard? 200 1979

My 79 262C Bertone is leaking brake fluid. From my best trouble-shooting it appears to be leaking from the brake line junction box. I think it maybe coming from the whole where the sensor goes in but I'm not sure. It is not coming from the master cylinder line and trickling down to the brake junction box. Anyways I was thinking about grabbing a junction box when I go to the boneyard tomorrow. I was already going to make a trip for some misc. stuff for the Bertone and Wagon so if I spot a clean looking box I thought it would be worth picking up.

Is there any advice as to replacing the junction box? What is the best tool for the brake lines without stripping them? What is the correct way to bleed the brakes w/o a pressure bleeder and with my wifes foot? Any and all advice will be welcomed. I hope to get the Bertone back for a smog check next week and would like to get the buttoned up before night fall tomorrow. Thanks for everyone's time.

Sincerely,
--
Julio Meza

1979 264GL B27F 123K --> BW55->M46, CLS, IPD Sway, 81+ Dash, Gauges

1979 262C B27F 159K --> Restore Project w/Possible V8

1984 245DL 209K -->Wifemobile






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Brake Junction Box (Brake Failure) Replacement, Easy or Hard? [200][1979]
posted by  Nickvjr  on Fri Mar 26 16:30 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.