Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

VDO gauge install 200

uid 23557's pic
posted by  jotunheim on  Mon May 3 15:40 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I will be attempting to install both a voltmeter and ambient temp. gauge tomorrow on my 1990 244 DL and have a couple of pre-install questions.

(a) I have both bezels and rubber feet, but don't see how the feet are needed (or used)with the VDO screw connections to the bezel.

(b) What's the easiest way to wire these? I haven't been behind the dash yet, but have a Bentley guide to get me that far. The instructions with the gauges are overly generalized for all applications, so I was hoping someone could help me out. i.e. should I use snap connectors, solder (yuck), or what to the wiring harness?

(c) Should I use the green light bulb filter or leave alone to best match the dash lighting?

Any info would be much appreciated..Thanks!

Jason






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New VDO gauge install [200]
posted by  jotunheim  on Mon May 3 15:40 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.