Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Long banjo bolt 200

posted by  someone claiming to be Skip on  Thu May 27 02:46 CST 2004 [RELATED]

I'm making some mods to my B21FT engine and am looking for what is apparently a non-Volvo part. I need a banjo bolt, the 12mm type that holds most of the CIS lines to the fuel distributor. The catch is I need a longer than stock one to enable me to connect 2 lines to the same port on the dist. I spotted this mod on a SAAB 900T and was told the bolt came out of an older SAAB (probably Canadian)or possibly a VW. Since most of my experience is with Bricks, I have no reliable SAAB resources. Can anyone help? Thanks as usual. BTW, this will be used to feed a cold start injector installed in the elbow just before the TB on my rally car. Worked like a charm in the 900T. It's fired by a switch that indicated WOT or high boost.

Skip
'93 850GLT
'83 242TI Flathood






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Long banjo bolt [200]
posted by  someone claiming to be Skip  on Thu May 27 02:46 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.