Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Question regarding wiring of Auxiliary gauges...Need to have gauges come Alive on positions II, III in Ignition 200 1985

posted by  Antiriad on  Thu Jun 10 11:10 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Jun 27 09:36 CST 2011
[RELATED]

I just finished installing an extra set of gauges in my 85' 240. I used 3 Generic 2-1/16 gauges for Volts, Air/Fuel Radio and Boost/Vacuum.

I used one of the screews in the Dash panel as a ground point for the gauges and as a POWER point I pluged the power wire using a spade connector to the fuse box. Right now the Gauges come alive when the key is on Level I position. However, I would like to have the gauges live one in the Level II, III positions. Is there a point in the fuse box which is live only in Positions II,III or maybe a POWER point for the factory Aux gauges I can tap into?

Thanks






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Question regarding wiring of Auxiliary gauges...Need to have gauges come Alive on positions II, III in Ignition [200][1985]
posted by  Antiriad  on Thu Jun 10 11:10 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.