Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2010 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Ballast resistor K-Jet 200 1981

posted by  sejose on  Sat Jun 12 17:10 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Greetings all

Checked the resistance across my ballast resistor, specs say .9 ohm plus or minus .1, mine reads 1.2 ohms. Out of spec, but it doesn't seem by much. Should this be replaced based on the 1.2 reading?

Car right now starts but doesn't idle, haven't had much time yet to troubleshoot. Car always has had rough idle.....


If ballast should be replaced, does anyone have a cross reference to a commonly found (GM Mopar or Ford) resistor??

Thanks!
Scott






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Ballast resistor K-Jet [200][1981]
posted by  sejose  on Sat Jun 12 17:10 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.