Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2014 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Rear rotor dust shield removal ,hard? 200

posted by  Trev29 on  Sun Jun 27 01:08 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 17 05:56 CST 2014
[RELATED]

I went to pull a rear rotor dust shield from my parts car and it looks like I'll have to disassemble the axle end to get it off. If this is true then should I try cutting it off instead? Ie. I don't want to open up and reassemble two axles ends (donor car and receiving car) cause I haven't done it before.
--
1980 245 Canadian B21A with SU carb and M46 trans






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Rear rotor dust shield removal ,hard? [200]
posted by  Trev29  on Sun Jun 27 01:08 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.