Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2015

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

240 turbo oil cooler 'stud' removal

posted by  boostedbrick on  Sun Jun 27 17:34 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Aug 12 10:14 CST 2013
[RELATED]

Hey Folks-

Out stripping what was left off an 85 turbo 240 tonight. Grabed the oil cooler, lines and cooler t-stat housing to eventually put on my 86 DL. How do you remove the "stud" that the oil cooler t-stat housing/oil filter screws onto? I can feel some type of a tool flat on the end of the stud where the filter would normally go, but nothing I had fit. I tried metric/SAE allens and 3/8 square plug. I would like to be able to remove the stud to go with the other parts when it is time to install on the DL, since the non-oil cooler cars don't have the extra length to accomodate the t-stat/line housing.

Thanks!

Jeff

86 244 DL
82 245 GLTi (project car)







<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.