Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2016 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Installed Turbo Sway Bars on 1992 245 200 1992

Folks,

Over the weekend I installed a 23 mm front sway bar and 19 mm rear sway bar on my 1992 245 (Cost $25). The goal was to improve the handling at minimal cost and try to get the wagon to handle as well as an original turbo wagon. I must admit that the whole process took me longer than it probably should have (about 4 hours), but I learned a lot and feel that I can easily replace the rear shocks or springs now. I'm glad I also got to use my new air compressor and air ratchet.

The end link bushings look a little tired, so I hope to upgrade to some poly ones before the end of the summer. Overall the car seems to roll less in corners. I have 15 inch Virgo rims and 205 65/15 Goodyear Regatta2 (sp) tires.

Any suggestions for other budget conscious upgrades?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Installed Turbo Sway Bars on 1992 245 [200][1992]
posted by  Dan Marino  on Mon Jun 28 06:29 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.