Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2011 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

how to convert small VDO turbo gauge into a pressure gauge? 200

posted by  seyed_ali on  Thu Jul 1 10:45 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Jun 18 13:54 CST 2009
[RELATED]

i got a heads up from one of the guys here that i can convert this...or rather it's already ready to be hooked up via a vacuum line, which will then measure manifold pressure via the vacuum line. I looked at my gauge...and i can't figure out how to do this????

There was a small depression in the middle, but it didnt' look like a plac i'd stick a vacuum hose in?.


THen there was a brass nipple depression near the ground, but it won't come off either. ANd there isnt' anything on the brass nipple to move..if i was to hook up a vac hose to it???

Greg??

any help would be appreciated.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New how to convert small VDO turbo gauge into a pressure gauge? [200]
posted by  seyed_ali  on Thu Jul 1 10:45 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.