Volvo RWD 700 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2006 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

nut size for header pipe to manifold 700

posted by  interstition on  Sun Jul 11 12:49 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Apr 28 10:13 CST 2014
[RELATED]

The exhaust on my '91 745 n/a has been noisy since I got it. I finally installed the Starla, cat back kit from FCP Groton. It's a good, solid, easy to install kit though mine was missing one easily obtained clamp. Unfortunately, I still have a lot of exhaust noise up front. In looking what I would have to do to replace the gasgets, I found that there are NO nuts on the two studs holding the header pipe to the exhaust manifold. I bet that will make anyone noisy. I know the gasket there may be shot, but I would like to see how it sounds if it's actually tight first. Does anyone have a good idea what size nuts go on those studs so I can pick some up without too much trial and error ? Thanks!
--
Andy in St. Paul, '91 745 Regina 190K mi, '89 244 137K, '87 245 RIP






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New nut size for header pipe to manifold [700]
posted by  interstition  on Sun Jul 11 12:49 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.