Timing is dead on, did not remove timing belt, no teeth are missing.

I have spark to each cylinder. New plugs, wires, coil.

Fuel pressure is 42.5 psi, new main pump, new filter.

Diagnostic computer shows NO codes!

Replaced four feet of vacuum hoses.

Other hoses (i.e. foam covered hose over top of engine) have been "checked" and are connected and not loose.

Engine idles somewhat laborious, BUT the main problem is I've got NO acceleration. Took off turbo hoses and turbo spins freely, tiny bit of oil, hoses are barely damp.

Obviously I've done something during water pump replacement, but what else should I check? Time for DEALER?!!

thanks



--
Mike in California '90 740ti Wagon- Hydrogeology Field Vehicle