Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2010 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

I chipped the crank pully/harmonic balancer 200 1987

posted by  myoder on  Thu Aug 5 07:34 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Mar 5 12:40 CST 2013
[RELATED]

I decided after much frustration to use the starter moter to remove the crank pully on my B230. IT seemed to work fine but when I removed the pully and looked at it, i found that I had chipped the slot where the little guide pin deal goes. The guide pin is slightly chipped also but I think it will be fine. THe harmonic balancer chip doesn't seem too bad but I am still worried about it. Is there a possibility of doing more damage to the guide pin buy reusing the harmonic balancer with the chipped slot? At this point I think I will just reuse it and pray that it holds ok!!!

TIA






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New I chipped the crank pully/harmonic balancer [200][1987]
posted by  myoder  on Thu Aug 5 07:34 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.