Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Header Pipe Hanger Bolt(s)? 200

uid 24984's pic
posted by  Yellow Brick Road on  Sun Aug 8 05:46 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Thanks to to fellow brickboarder's advice, the old header pipe came off easily. Next question: The is a steel support bracket bolted to the side of the tranny that crosses above the old header piper at a right angle. The support bracket has two oval holes in it. There was nothing between this bracket and the header pipe!! The new header pipe also has two welded brackets with threaded holes, top and bottom. What part(s) do I need to get early tomorrow morning from the Volvo dealership that connect the header pipe to its support bracket?? Thanks in advance for your time and help.

Scott
1987 240DL Wagon






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Header Pipe Hanger Bolt(s)? [200]
posted by  Yellow Brick Road subscriber  on Sun Aug 8 05:46 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.