Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Goin' to the junkyard.... 200

posted by  someone claiming to be Blake on  Mon Aug 9 15:47 CST 2004 [RELATED]

Good day fellow Brickers,
Tomorrow I'm going to the junkyard of bricks, and I was wonding, since this is a pick and pull, what tool (sized sockets, ratchets, box end, so on) would i need, or should have with me. I know they use 13mm and 10mm a whole lot, but anything else? I'm pulling parts off of a turbo 240 for my project car, which i will be turbocharging hopefully... So anything special i need there? I already have the turbo, manif., and head. So i need the intake plumbing, oil pan, so on. Also I have a new 240 (93). So what downpipe can i use? I heard something about using a 740s? or am i mistaken? Finally, the turbos apart and i need new seals and bushings, anyone know a good place for parts?
Thanks a whole bunch,
Blake






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Goin' to the junkyard.... [200]
posted by  someone claiming to be Blake  on Mon Aug 9 15:47 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.