Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2005 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

121 Wagon (221) Exhaust Mounting 120-130

posted by  someone claiming to be Mat Norris on  Wed Sep 1 00:10 CST 2004 [RELATED]

Hi,

I have a amazon wagon with a stainless exhaust system - std bore I think.
The rear pipe keeps on clattering against the bumper(fender?) when going over bumps. I have replaced all the joint clamps and orientated the exhaust in the best potion but still it occurs. The rear section of the exaust is hung from the underneath of the car by rubber exhaust hangers (Basically two 9 mm cross-section rubber bands with a overall diameter of about 40 mm) Is this the correct hangers as they offer very little resistance to the pipe moving upwards towards the fender. I have seen these hangers on Ebay

http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&category=10432&item=2488213353&rd=1

which would offer some upward resistance - is this the sort of thing I should have? Thanks






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 121 Wagon (221) Exhaust Mounting [120-130]
posted by  someone claiming to be Mat Norris  on Wed Sep 1 00:10 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.