Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Hooking the steering rack back up... I'm almost there 200 1982

posted by  mackinta on  Sat Sep 4 14:28 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Jul 3 01:33 CST 2007
[RELATED]

I took earlier recommendations not to try rebuilding my ZF steering rack, and glad that I did, considering the apparent simplicity of the step that's stuck me.

What's the trick to get the pinion back into the receptor on the end of the steering column? With the U-Joint flopping, the clumsiness of the rack, and the tight fit of the friction joint, I can't finagle it.

Is it easier to maneuver the pinion in with the rack totally unattached? Do you somehow "paralyze" the U-Joint? Should I bolt the rack down and snap the joint to push the receptor on? Has anyone had luck putting a wedge of somekind into the flange on the U-Joint to open it up? I couldn't jam a flathead drill bit in there enough to stick. Work from the top or bottom? Lubricants? I was really floundering out there today and wish I could drive it to a shop. With that option out, I need your help!

Thanks for any advice, Andrew






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Hooking the steering rack back up... I'm almost there [200][1982]
posted by  mackinta subscriber  on Sat Sep 4 14:28 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.