Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 3/2005 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Rear trailing arm bushings - rubber or poly? 200 1986

I will soon be replacing worn out rear trailing arm bushings and am trying to decide between Boge rubber bushings and polyurethane bushings. My main concern is the harshness of the ride and additional noise with the poly vs. rubber. If there is not a significant difference in the ride/noise, I'd be tempted to go with the polyurethane bushings for durability and what sounds like a slightly easier install. Thanks in advance for the advice!

Tom
'86 245 DL 232k






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Rear trailing arm bushings - rubber or poly? [200][1986]
posted by  tvg  on Wed Sep 29 17:05 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.