Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2006 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

960 Brakes and Bushings 900 1996

posted by  FletchFFletch on  Fri Nov 12 04:29 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Oct 17 05:42 CST 2011
[RELATED]

Bushings:

The front lower control arm bushing (rear position) are shot. Does anyone know how hard it is to press these in and out? I see there's a tool on ebay:

search.ebay.com/Volvo-Support-Arm-Bushing-Tool-960

I am not sure if this tool will fit or not. If at all possible I would consider buying a cheap press and doing it myself instead of paying the dealer. Any idea if a 6 ton press would do it or should I go with a 12 ton? (looking at harborfreight.com)


Brakes:

If I step very hard on the brakes there is a loud "CLUNK". I'm assuming that is from the worn bushings. When I did this I noticed that the right front tire would skid a little bit. The ABS should prevent that. The ABS fault light is not on so I am wondering what would cause this?

Thanks

Fletch






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 960 Brakes and Bushings [900][1996]
posted by  FletchFFletch  on Fri Nov 12 04:29 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.