Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Transmission line pinhole 200 1984

posted by  ACK on  Sat Nov 20 11:50 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Greetings.

I had a minor transmissio leak. This morning I decided to locate its source. It is where the two transmission line meet and there is an aluminum crossmember over the lines. I removed the crossmember and I noticed a severe wear on the line and a small pinhole.

According to previous postings the solutions were:

1 Flexible tubing and two clamps
2 Rigid tubing and two compression fittings.

I could use method 1 as a stop gap measure, I prefer method 2 and reinstall the aluminum crossmember, however What is the size for the compression fittings?

The tubing that I measured miked at .320, apparently too large for 5/16 or for 8 mm (.315)

Thank you for our response


AC





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Transmission line pinhole [200][1984]
posted by  ACK  on Sat Nov 20 11:50 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.