Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

heater control valve 200 1980

posted by  billy242 on  Wed Dec 15 08:32 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Sep 8 05:10 CST 2010
[RELATED]

Ok, I have unsuccessfully searched the archives and didn't find the info I need. My heater control valve in my 1980 242 is apparently not working. I went outside a little while ago and finally located where the valve lives under the dash. Question is, how does one go about removing/replacing this thing? It seems that the screw heads securing this thing to the car are not accessible from the driver's side foot well. The heater hose clamps don't seem to be very accessible either. Do I have to remove the whole centre console just to ge this thing out? Any special tricks or secrets involved? I would love to get my heat working, as it is going down into the 20's at night and only getting into the upper 40's/low 50's during the day even here in Louisiana. I would drive one of my other 2 cars ( a Datsun and a Ford) during this cold spell, but their heaters are not working either :(

Any hints, tips, tricks or secrets would be greatly appreciated.

billy242
1980 242DL/GT
1977 Datsun 280Z with Chevy 383
1967 Ford Fairlane 500 2 door sedan






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New heater control valve [200][1980]
posted by  billy242  on Wed Dec 15 08:32 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.