Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Need an advice: How to cope with coolant leak thru upper seal of the water pump? 200 1987

posted by  SilverBlueWagon'87 on  Mon Dec 27 16:51 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Jun 8 16:11 CST 2008
[RELATED]

Hello, all Volvo gurus and enthusiasts!

I need an advice on how to cope with the following problem... The water pump on my car is leaking thru the upper seal (O-ring) at the place where the pump meets the engine head. The pump itself is relatively "young" - some 2-3 years old, not leaking and working fine. The main seal and the seal at the return pipe are fine too. Actually, when on the run and the engine is hot, the pump is not leaking, but when the car is left overnight and the temperature falls below zero, every morning I see a little puddle of coolant on the pump surface, just near the upper seal.
Now, the question… Is it possible simply to unbolt the pump slightly and then pry it up to tighten the upper seal, or I’ll have to replace all the seals? Maybe there is some sealant that could be put over the upper seal?
Any advice is thankfully accepted.

Sincerely,
Dmitriy.

--
240DL 1987 silver-blue wagon, >240K miles.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Need an advice: How to cope with coolant leak thru upper seal of the water pump? [200][1987]
posted by  SilverBlueWagon'87  on Mon Dec 27 16:51 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.