Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2018 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Tire vibration between 55-60 200 1993

posted by  someone claiming to be Teal 240 on  Tue Feb 22 14:33 CST 2005 [RELATED]

I had a broken stud on the rear wheel and needed to replace the rotors as well. When I replaced the rotor with a new one and replaced the stud with an FCP Groton stud it appears I have a vibration from that wheel. To replace the stud, I was able to 'cheat' and not take off the hub, but feed the new stud back through the hub by removing the parking brake shoes. Then I was able to gradually tighten the nut to press the stud into the hub. But now I notice a vibration that I did not have before driving on the broken stud. I thought it may be the wheel/tire so I swapped it with the front wheel and the problem is still there. You can drive through it, ususally it goes away at 65. Did I warp/bend the hub? How much of a hassle would it be to change it if I did?


Thanks in advance, fellow Bricksters!

My Teal 240
93 240 109,000 sporting a fresh repaint!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Tire vibration between 55-60 [200][1993]
posted by  someone claiming to be Teal 240  on Tue Feb 22 14:33 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.