Frieda has Sunex tinted Glass!!! But.... The left vent wing was busted out by the the Dork Boy PO. Anyone got a spare one they would like to sell?

I cleaned the windows today of 25 years of grime and they wouldn't come clean. I got to looking, and the windows are factory tinted. Needless to day, I was pleasantly surprised!!

On a lesser note, the front fenders have a significant bit of rust in the upper and lower rear corners. I have a pair of totally rust free ones on my wagon that I am gonna steal to get the the car into the paint shop. I guess I will go head and buy the rust free 4 door I have been eyeing that has the Yankee bar.

Hey Damian..... What offset did you have your your widened Amazon wheels welded at: 1 inch?

The upholstery guy had a vinyl that matches almost, perfectly, the orIginal stuff. I think I will replace the two torn panels that need replacement and retain as much of the original as possible.

Freshened up the B20B with new standard bearings and put Deves rings in the freshly honed cylinders. Total oversize from standard is still just over .002". So far so good. Drive line is out getting shortened for the OD. Hopefully, I can install the drivetrain this week?

Did lower front bushings this week.

Probably sand it and put an even coat of epoxy primer on it and drive it for a while as a semi "rat ride" for a couple months or so till the wagon has the body work done!!

The journey continues.

Everyone have a good week!!

Mike