Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

240 distributor replace 200 1987

posted by  Marlin Mangels on  Mon Apr 18 11:41 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Oct 21 15:41 CST 2014
[RELATED]

The Hall effect connector broke and left me stranded today (one block from home, no problem). After work I went back to the car and the car started. It would appear that the wires are intact, but that the broken connector allowed one of them to ground against the distributor. I epoxied the connector back to the distributor and now need help to re-install the distributor. I rotated the crank until the cam sprocket was aligned with the mark on the cam shield, then backed the crank (ccw) until the timing mark on the crank pulley roughly lined up with the 10 degree BTDC mark. If I re-install the distributor with the rotor pointing at the #1 plug position and the crank/cam in this position, will I have the correct timing? Thanks.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 240 distributor replace [200][1987]
posted by  Marlin Mangels subscriber  on Mon Apr 18 11:41 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.