Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2003 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Scan Tech front springs from Groton 700

I have an 89 760 that I would like to replace front springs and struts. I have already done a conversion on the rear from IPD for the Nivomats, and it is still a bit high in back.

Since the 760 is designed to have a softer ride - would it be a good idea to go with 740 springs (which I would figure might be a bit stiffer).

I note that Groton has both in the Scan Tech. Also I was thinking that a bit stiffer spring might give the front a bit of a lift, and also balance better with the IPD conversion.

Opinions, experience??

Thanks
Andy Smith
--
'Be blessed in your quest'' 89 764 (110K), '94 940T (180K)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Scan Tech front springs from Groton [700]
posted by  Andrew in AL subscriber  on Sat Apr 23 11:00 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.