Volvo RWD 140-160 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2010 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Hey MS'ers got a quick question 140-160

posted by  someone claiming to be kingcong on  Sun Apr 24 10:18 CST 2005 [RELATED]

I've finally started my MS install and i'm trying to figure out the best placement for the IAT. I have the K&N cone on my D-jet intake which doesn't leave alot of room to mount it. I figure I have 2 options:

1. mount it in the chrome plate at the front of the cone filter, however I wonder if this area gets enough airflow for the sensor to function properly.


2. Mount it where the cold start valve is located on the intake manifold. I won't be needing that injector for MS. Would it get too warm here for the sensor to function properly?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Hey MS'ers got a quick question [140-160]
posted by  someone claiming to be kingcong  on Sun Apr 24 10:18 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.