Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2005 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Poor fit of Nissens radiator 700

posted by  jim e on  Mon May 16 12:58 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Jun 29 14:37 CST 2011
[RELATED]

I just replaced the original radiator on my newly acquired 744GL. It had started leaking at the left rear vertical seam - not bad longevity for 16 years and 190K miles. The new Nissens from FCPGroton fits, but is loose in the mounting brackets. It seems like the new radiator is about 3/8 inch too short. The top rubber lined clamps don't hold it securely. I can wiggle it back and forth, although not enough that it would fall out. I'm a little worried that because it can move, it may vibrate enough to shorten its life. Has anyone encountered this problem, and have a solution? Should I get new rubber mounts?
--
Jim Egelston - Seattle - '81 245DL, '85 244GL, '89 744GL, '94 945T, '89 535i, '74 R90S






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Poor fit of Nissens radiator [700]
posted by  jim e  on Mon May 16 12:58 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.