Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2011 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Heater Blower Motor Connector 700

Hi Guys
Is anybody running a Delco Blower motor in their 740s?
Well,on the recently acquired 90 740 GLE 16 valve the blower motor was running fine till last week when it stopped.Fuse,motor all are ok after pulling them out and checking them.I found the culprit as being the connector(female housing part)that connects into the male housing (in the motor ).The 2 metal connectors inside the plastic housing are rusty,completly destroyed. I have been trying to get this connector/housing at local,away(FCPGroton) auto parts,boneyards without any success.It looks to me that the motor or connector are not original(?)as the wires(2)leading to the connector seem to have been mended 6/7 inches above it.I don't think I'll have much success at a dealer,either...
Does anybody know where to get one of these with 2 wires attached (so I can mend
them)? Connector housing is white plastic 1"X1" about.Housing is the female side.However the inside metal connectors are the male side of spade type connector.
Tks for any kind of help.
--
00 S40 40K,90 740 152k ,87 740 340K and 80 240 265K both gone but not forgotten






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Heater Blower Motor Connector [700]
posted by  BEMFICA1  on Thu May 19 05:49 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.