Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 8/2001 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Self diagnostic unit question 200

The '89 wagon is running okay but I decided to have a look at the self-diagnostic unit just to familiarize myself with it. I ran the procedures according to Bentley.
I did the ignition system checks first. No codes were stored and I got the correct response for the other couple of tests described.
I moved on the to the fuel injection tests. Once again no codes were stored. So I went on to ECU input tests. The additional tests got the correct codes until I got to the AC test. The engine was running and I turned the AC switch on. According to Bentley, if no problem is occuring I should have seen code 1-1-4. I got 1-3-4. I figure I should get either the correct code or the LED should continue to flash rapidly, indicating a problem. Is this another Bentley misprint? They give 1-3-4 as the correct display for LH 3.1 but mine is 2.4.
I also did the ECU output tests and got strange results but I just now realized I was doing it wrong. The book says 'ignition on' and, like an idiot, I still had the engine running. I'll check that again later.
--
'80 DL 2 door, '89 DL Wagon






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Self diagnostic unit question [200]
posted by  bulletproof subscriber  on Mon May 30 07:48 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.