Volvo RWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 11/2020

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

960 still won't stay running! Any advice?

My 93 960 Runs for 3 seconds and dies. I've replaced all wiring between power stages and coils, coils and Ign relay. All grounds are clean and added new between battery, ps's, engine and chassis. PULLS NO CODES EXCEPT 1-1-1 on all ecu's - except when I forget to pull something back in(cam, tps,ect). I've tried replacing with other parts: ECU 3x, cam sensor 3x, crank sensor 3x, ect 2x, fuel relay resoldered 3x, ign \fuel underhood relay -had 1 exta switched between both, ign switch, tried direct power to underhood ign and fuel relays. 43# + fuel pressure, new fuel filter and intank pump. Bypass fuel pump relays. Clean throttle body, flame trap. Replaced IAC 1x. Won't stay running on carb cleaner or starting fluid. What's our best advice dynamite, gas and a flare?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 960 still won't stay running! Any advice?
posted by  surfindude  on Tue May 31 05:11 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.