Volvo RWD 140-160 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2019 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

intake/exhaust manifold seperating? 140-160

posted by  cardog on  Tue May 31 14:24 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Oct 13 10:29 CST 2014
[RELATED]

Hi,
I am about to pull my carbs and manifold off of my '72 142. I'm looking for a vacuum leak so I am replacing all of the gaskets and checking for cracks in the siamese intake/exhaust manifold. If I have tocut the manifold to seperate the two, (I have an aluminum intake if I need it)is their a best spot to cut it? ...and what is the best tool to use?
I haven't looked at it yet, so this question may be a bit premature, but I figured I should get involved with as much info as possible.
Thanks,
CU






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New intake/exhaust manifold seperating? [140-160]
posted by  cardog subscriber  on Tue May 31 14:24 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.