Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

High crankcase pressure - clean flame trap 200 1991

posted by  anderssj on  Thu Jun 2 15:22 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Oct 23 17:03 CST 2014
[RELATED]

Hi,

Going over my son's 240 yesterday, I noticed a slight oil leak from up between the engine and trans--the car has always been bone dry up to this point. Loosened the oil filler cap, and it "danced" pretty well on top of the valve cover--pressure seemed much higher than usual. I'm curious as to why the pressure would be high . . . .

I checked the flame trap, it was clean--so were the various hoses I could reach from the top side of the engine (the thin to the intake manifold, the big one from the top of the trap to the corregated hose between the mass air sensor and the manifold). Also, I had cleaned out the black plastic separator about 2 years ago--I'd like to think that it's not completely plugged up yet.

Any ideas as to what's causing the high crankcase pressure? I'd like to figure out what's up before I lose a seal.

Thanks in advance!

Steve A-






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New High crankcase pressure - clean flame trap [200][1991]
posted by  anderssj subscriber  on Thu Jun 2 15:22 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.