Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2006 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

940 rear main seal replacement. What did I do wrong? 900 1993

posted by  Marlin Mangels on  Thu Jun 9 12:25 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Oct 21 15:41 CST 2014
[RELATED]

I replaced the rear main seal on my 945 last weekend. I was very careful and ran my finger around the crank before instlling the new seal (Volvo brown one). I didn't feel any rough areas. I checked the flame trap and it was clear. I did not remove the seal carrier. I've done this procedure before on my 740 and didn't have any problems, however the rear seal still leaks on this car. I see in the FAQ that this is not unusual, however the car now uses oil to the tune of 1 quart per 400 miles. What did I do wrong? I fear I'm going to have to takle this difficult job again. Is there anything I can do to keep from removing the transmission again? Thanks.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 940 rear main seal replacement. What did I do wrong? [900][1993]
posted by  Marlin Mangels subscriber  on Thu Jun 9 12:25 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.