Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2009 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

engine mount sequence 200 1989

posted by  someone claiming to be Andy on  Thu Jun 9 13:48 CST 2005 [RELATED]

Hey everybody. I am going to be replacing my engine mounts because one of them is cracked. I have read the haynes manual, and I was wondering if anyone had any advice. My plan is as follows:
1.) Put the front wheels on ramps
2.) Disconnect the negative battery terminal
3.) Put a jack w/ a piece of wood (I don't know what size to use) under the engine
4.) Unbolt the mounts
5.) jack it up some more, and take out the mounts and install new ones.
6.) lower the engine, and tighten the bolts

Good? Any suggestions? Thanks for the feedback!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New engine mount sequence [200][1989]
posted by  someone claiming to be Andy  on Thu Jun 9 13:48 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.